How To reset Dahua XVR password? DVR XVR full Guide

October 4, 2023 by Mustafa Rafique

In this guide, we’ll walk you through the process of performing a hard reset on a Duaha DVR model XVR reset Dahua XVR password lacks a reset button on its motherboard. Whether you’ve forgotten your password or need to reset your DVR for any reason, follow these steps carefully to regain access to your device without any hassle.

Introduction: reset Dahua XVR password

A Duaha DVR can be a valuable asset for your security needs, but sometimes situations arise where you need to perform a hard reset. This guide is specifically tailored to the XVR 1B04H model, which does not feature a conventional reset button. We’ll show you a step-by-step process to reset it effectively.

Step 1: Disconnect the Power Supply

The first step in resetting your Duaha DVR is to disconnect the power supply. This ensures your safety during the process and prevents any damage to the device.

Step 2: Locate the J1 Jumper

Next, you need to locate the J1 jumper on the DVR’s motherboard. This jumper is typically situated near the HDMI port or close to the power socket. It’s a small component that is crucial in resetting the DVR.

Step 3: Short the Two Pins

To initiate the reset, carefully short the two pins of the J1 jumper by connecting them. Keep them connected for approximately 20 seconds. This step is essential to trigger the reset process without the need for a reset button.

Step 4: Remove the Jumper

After the 20 seconds have passed, remove the jumper from the pins. This action is a pivotal part of the reset procedure.

Read More How to Connect a Dahua CCTV Camera to Your Mobile Device: A Step-by-Step Guide

Step 5: Reconnect the Power Supply

Now that the jumper has been removed, reconnect the power supply to the DVR. Make sure the connections are secure.

Read more Dahua xvr5104hs-s2 Wifi firmware Download

Step 6: Allow the System to Boot Up

Give the DVR some time to boot up. This process may take a few minutes, so be patient.

Step 7: Check for Password Reset

Once the DVR has fully booted up, check if the password has been reset. If the reset is successful, you should no longer be prompted for a password, and the DVR will guide you through the setup process.

Congratulations! You’ve successfully performed a hard reset on your Duaha DVR without a reset button. This method can be a lifesaver when you need quick access to your DVR and cannot use a reset button.

Conclusion

In this guide, we’ve demonstrated how to perform a hard reset on a Duaha DVR model XVR 1B04H, even if it lacks a reset button. Following these steps carefully will help you regain control of your DVR and ensure its proper functionality.

Latest Post

Leave a Comment Cancel reply